How To Put The Legs Down On A Folding Table
Cut 1 14-inch-square pieces of hardwood to the measurements.
How to put the legs down on a folding table. Measure and Mark the Folding Leg Locations. Place them between the legs on both sides and then measure the distance between the two short stretchers and cut. To secure the table lock the hinges on both sides of the table by pushing up on the elbow.
There is a simple pivot point that allows a table leg to fold to 90 degrees. This keep the legs from spreading apart and stabilizes the table by joining everything together. - Unfold one leg first then the other one so as to avoid any obstruction 1.
Open the legs wide minding that the cables are not trampled 2. Lifetime square table legs. This fold down work table will hold over 350 lbs.
At this blade depth the leg will receive a very small shave down. Cut them to size put them on. With caution and control gently pull the table upward until the legs rest of the floor.
Place a screw in each drilled hole and rotate clockwise by hand until it becomes too tight to continue. Finish the Wooden Table Top and Legs. It comes with two sets of 4 mounting buttons so you can mount 4 buttons inside your trailer and then mount 4 buttons on the outside of your trailer and then you can use the work table inside and out.
Push down gently on the center hinge while pulling the leg in the direction of said bracket. Run one of the longer legs through the table saw until the table has leveled off. I wouldve thought of that years ago Use 2 inch PVC pipe or underground water pipe.