How To Make A Homemade Table Saw Fence
Plans for this projecthttpsibuilditcaplanswooden-table-saw-fenceThe build article for this project with the original build video and installation vid.
How to make a homemade table saw fence. Drill a pilot hole into an end cap at one side of the 24 fence. Hey guysIts Mistry. I really recommend this plan because it is really easy to follow and very detailed.
Several pieces of square wood 0709 inches Plywood blades. In previous video i make homemade table saw so its became time to make a fenc. You want to rod to go through the end cap and be in line with the table base allowing you to screw it up against the base to secure it.
If playback doesnt begin. Holes were drilled and tapped into the legs to match the existing holes on the table saw table. Once drilled you can screw the rod through the end cap.
Measure first with the saw fence resting on the table. Several 50 mm wood screws. Drill.
One rectangular aluminum bar. Install the threaded rod screw into the end cap of one side of your fence. Drill the pilot hole all the way through the end cap.
Be sure you will get the best out of more than 4000 used machines and tools. This is the first video of a short series in which I build a homemade table saw. Measure first with the fence of the saw on the table.