How To Clean Bare Wood For Painting
To clean your hardware it may be easiest to remove it this will also make painting a smoother process.
How to clean bare wood for painting. Work efficiently by starting with a coarse sandpaper in the 60-100 grit range and gradually switch to finer sandpapers rated closer to 150 grit. Simply apply a small amount of the erasing compound on the surface of the unfinished wood and use some cotton balls to work the cleaning material into the grain of the wood. Buff it in circular motions with the clean dry cloth to remove all.
Using a paint roller instead of a brush will contribute to a smoother finish. Dust unfinished wood with a paintbrush that hasnt been used for painting. As such you should wipe the old wood surface with a mixture of 1 cup bleach 1.
Wipe down the wood again thoroughly to dry off all the areas you cleaned. The hand brush will get rid of rough pieces and bits. Clean thoroughly with sugar soap sand down with a fine paper to give a key for the new paint and then apply your paint.
Erasing compounds are elements used to remove dirt from bare wood surfaces. Sanding produces dust which may make it difficult for new paint to stick. Use a long-handled scrubber brush and a mild detergent to gently scrub away accumulated dirt grime mold and other residue.
To clean hardware we suggest using a 1 to 1 mixture of vinegar and water. Brush with the wood grain -- as if you were painting it -- to avoid creating visible dust streaks. Apply a coat of Rustoleum oil-based paint to the primed wood using the cleaned paintbrush.
It is the primary tool to clean the woodwork. Some hardware is tricky to remove so can be cleaned without removing from your piece. Apply the primer in a thick even layer.