How To Use A Table Saw Correctly

Push the board through the blade at a slow and steady rate keeping the board flush with the fence.

How to use a table saw correctly. Remember that even the Best Table Saw For Beginner can pose a threat if your mind is wandering. Stand to the side of and not directly behind the blade as youre ripping. Use a table or other outfeed support to hold the board as it leaves the saw.

After youve switched out the blades put on safety gear. In this video Ill show you tec. To do this use the arbor nut wrench that came with your table saw to loosen the arbor nut the nut that holds the blade in place and position the rip blade with the teeth facing the front of the.

Fit the appropriate rip blade into the blade arbor located at the top of the table and this should be after unplugging your table saw from the main power source. Its better to be safe than sorry. On the other hand a crosscut is simply cutting across the grain.

This will provide you with the best measure of control. Keep at least 6 inches between your hand and the saw blade. Learn how to use your tablesaw safely and effectively.

Always set the length to be cut with a measuring tool and then line the mark up by eye. This process may differ depending on the type of saw that you are using. When your right hand reaches the edge of the saw table pick up the push shoe and hook it over the back edge of the board.

When you get near the end of the board use a push stick to push the rest of the board through. Dont wear baggy clothing and always we cant stress this enough wear safety glasses. You just need to make one investment to sharpen your table saw blade.