Make Your Own Wood Lathe Chuck

With the chuck on the lathe turn the lathe on slowly and using a skew clean up any rough edges and remove any loose rubber.

Make your own wood lathe chuck. Making the four jaw chuck. Put the jig on the lathe and bore a 516-dia. At this point you can unscrew the disks but keep the faceplate attached.

If I get enough questions Ill make a FAQ video for it This video is very speci. TEKNATOOL SUPERNOVA 2 SUPERNOVA2 23245 Chuck Kit with JSCOLE jaws JS25N jaws JS100N jaws Woodworm Screw PLUS JS50N 2 jaws NCSC Chuck Spur 4mm Bondhus Hex Key for fast jaw changes Supernova 2 23245 Kit plus 2 Jaws Chuck Spur Bondhus 4mm Hex Key for Fast Jaw Changes Includes SN2 chuck JSCOLE jaws JS25N Jaws JS100N jaws Woodworm screw Fasteners PLUS JS50N 2 jaws NCSC Chuck spur Bonhus fast change hex key THIS IS AN ISERT TYPE CHUCK. I made a drill powered minipen lathe using roller blade wheel bearings and a couple of scrap pieces of plywoodFor futher information check out my insructab.

A piece of threaded rod will go into each of the four slots. I managed to build this lathe in about a week with not much more than a cordless drill a drill press a jigsaw and assorted hand tools. If playback doesnt begin shortly try restarting your device.

As the name implies the jam chuck is jammed up against a reversed wood bowl interior surface to make a firm contact point. A screw chuck is a very old and very handy way to hold a lot of projects such as bowls and platters on a wood turning lathe. Wood Turning Bottom Jaws.

To Build Your Own Wood Lathe in 30 Minutes You Need. Cut a hole for the faceplate which remains in place. When the caulk is dry it is time to mount it to the lathe and finish it up.

This needs to go in fairly precisely. Videos you watch may be added to the TV. The simplest home-made chuck is a waste block of wood glued to the bowl blank and used for holding.