How To Sharpen A Wood Lathe Parting Tool

Focus on removing an equal amount from both faces so that the point remains centered on the tool.

How to sharpen a wood lathe parting tool. The same amount of time turn the parting tool over and do the opposite side. At length the result must be the point of the parting tool to be ground to a sharp squared point. The tool should protrude 2 from the jig and your varigrind should be set at a 23º angle.

Then simply place the lathe tool at a 45-degree angle with stone. Attaching Handles to Your. This lets you know youre making appropriate contact.

Make sure your bench grinder is fastened securely to the floor with no wobble or give. How to Sharpen Wood Turning Tools. You can get 30 minute epoxyyep just click on that link or check out your local big box store.

If playback doesnt begin shortly try restarting your. A demonstration on how to sharpen a lathe parting tool. A good thing to watch for is sparks that are along the edge.

The end result should be the point of the parting tool be ground to a sharp squared of point. Turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel for a few seconds. Next fasten your tool into the varigrind jig.

Learn how to sharpen a parting tool on your bench grinderShop sharpening supplies. As you sharpen and make contact move your wood lathe tool gently from side to side to get the entire edge. Make sure you clamp up the handles nice and tight wipe off any excess epoxy that oozes out from the handles being squeezed together.