How To Prep Wood For Sanding
Then switch to fine sandpaper 200 grit until the entire piece is uniform.
How to prep wood for sanding. Remove the Baseboards Before Sanding. For smaller wood items like furniture wash the wood. Wipe down the whole surface with a tack cloth to remove any dust from sanding.
On certain woods such as oak and ash pre-wet the wood with a damp cloth to raise the grain before final sanding. Mount 7-inch sanding discs onto it for sanding the primary surfaces and then switch to 5-inch sanding pads for. To sand between chair spindles wrap a strip of sandpaper around the spindle and work it back and forth like dental floss.
Using a damp towel wipe down the wood. If it snags youll need to re-sand the area. It is the primary tool to clean the woodwork.
Sand the wood twice with a medium grit sandpaper 100 to 120-grit and twice with a fine grit sandpaper to remove any imperfections and prepare the surface for stain. To check your work run a sock over the sanded wood. The hand brush will get rid of rough pieces and bits.
Go around with a hammer and make sure you sink all of these nails back into the hardwood floor. When the wood dries sand. Using a nail punch ensure all nail heads are below the surface of the floor.
Also the brush fibers could clean dust from tricky holes or corners. This will provide a smoother final finish. What it does is open the pores of the wood to allow it to take the stain evenly and deeply.