How To Prep Wood After Sanding
Use a scraper to remove loose paint from the siding working from every direction.
How to prep wood after sanding. Give them a good scrub using a sponge or cloth. Apply oil-based paint primer. It takes four steps to sand wood to perfection.
After youve sanded the wood go over it with a rag to wipe it down and remove any excess material. While you can use any cloth to do this a tack cloth will pick. For smaller wood items like furniture wash the wood.
Before sanding scrape loose and flaking paint from the siding. Pound-in any protruding nail heads. Pour the mineral spirits over the stripped area and use the steel wool to wipe away any remaining stripper residue be sure to follow the wood grain.
Not damp and not dripping but somewhere in the middle so that every inch of the wood is wet but with no puddles. After stripping paint to properly clean the wooden surface use mineral spirits and fine steel wool. Choosing a pre-stain wood conditioner is simple.
Some paint scrapers are made with a handle that can be used as a hammer head for this. If you plan on using an oil-based stain you must use the oil-based Minwax Pre-Stain Wood Conditioner. Then be sure to remove any excess with a clean dry cloth.
If you still have paint or varnish remaining on your wooden project you can repeat the stripping process and again use mineral spirits and steel wool to. Wash the entire wood surface once youre finished scraping andor sanding. On certain woods such as oak and ash pre-wet the wood with a damp cloth to raise the grain before final sanding.