How To Make Your Own Hammer Handle
Pritchel hole Round hole in an anvil used when punching holes.
How to make your own hammer handle. Reins The long handles on tongs. Place your fingers near the top of the nail when holding it. Place hammer handle on one hook and ball on the other hook.
The wedge can be sawed out on a band saw and should be an inch or more longer than needed. A C-clamp and thumb screw hold the mold together until the metal has set. I like to chuck a 516 to 38 diameter twist bit into a drill tighten the tool head in a bench vise whats left of the handle pointing down then drill out as much wood as possible from within the hole in.
3 Drill the hole for the tool. You only need a few item to make a hammer handle. Remember inside surface of hook to inside surface of hook should be 10 inches because wires are measured inside of loop to inside of loop.
Linseed or Tung oil or other finish. The top of the axe that the head hangs on is known as the eye of the handle. You can also make your own steel-handle hammers using molds handles and lead hammermetal all sold separately.
Grip the hammer near the middle of the handle. If you hold the nail near the bottom a missed hammer swing will crush your fingers between the wood and the hammer. Auger out enough wood from the hole in the hammer or axe head and the entire handle will come out.
Oak is not the best wood and some oaks are better than others. Looking customize your M1 or M4 titanium handle hammer. 2 Select the blank you intend to use place it between centers and turn it round.